Stranded, braided, and shielded wire assemblies for demanding environments.

To be clear about scope: we do not draw copper or build raw cable. We buy engineered stranded, braided, and shielded wire and cable and manufacture it into finished assemblies — terminated, protected, marked, tested, and documented.

If you need bulk conductor on a reel, a mill or distributor is your source. If you need those constructions turned into a repeatable assembly that passes your incoming inspection, that is our work.

Stranded wire exists because things move. Robotics cable carriers, articulating medical devices, and vehicle-mounted equipment all flex their wiring for years, and a build that ignores that fails early at the termination.

High-strand-count wire needs its own attention: correct contact selection, crimp tooling set for that strand configuration, and pull-force validation to confirm the joint. We set tooling per construction rather than assuming a gauge alone tells the story.

A shield only helps if it is terminated the way the design intends. Foil with a drain wire, tinned copper braid, or a combination each behave differently, and pigtails, ground rings, and full 360-degree backshell terminations are not interchangeable.

We build the shield termination your drawing calls for and verify shield continuity before shipment. If a callout looks likely to create a noise problem in the application, we raise it during the build review.

Braided sleeving handles abrasion where a harness rubs, spiral wrap allows break-outs along a run, and heat-shrink and overmolding seal transitions where fluid or vibration is a factor. We apply what your environment needs and what your print specifies.

Send drawings or a BOM any time — uploads are accepted 24/7 and our USA-based Sales team responds during business hours.